This shows you the differences between two versions of the page.
| — |
gnucap:manual:commands:outfile [2015/12/11 15:39] (current) |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| + | ====== ">" command ====== | ||
| + | |||
| + | ===== Purpose ===== | ||
| + | |||
| + | Saves a copy of all program output (except help) in a file. | ||
| + | |||
| + | ===== Syntax ===== | ||
| + | |||
| + | > file | ||
| + | >> file | ||
| + | > | ||
| + | |||
| + | ===== Comments ===== | ||
| + | |||
| + | ''>'' creates a new file for this output. If the file already exists, the old one is lost, and replaced by the new one. | ||
| + | |||
| + | ''>''''>'' appends to an existing file, if it exists, otherwise it creates one. | ||
| + | |||
| + | A bare ''>'' closes the file. | ||
| + | |||
| + | ===== Examples ===== | ||
| + | |||
| + | > run1 | ||
| + | Save everything in a file run1 in the current directory. If run1 already exists, the old one is gone. | ||
| + | >> allof | ||
| + | Save everything in a file allof. If allof already exists, it is kept, and the new data is added to the end. | ||
| + | > | ||
| + | Close the file. Stop saving. | ||